IPM-1SE - Single E1/T1/J1 over IP/Ethernet extender - TDMoverIP - DC48V power

<< Previous in E1 and T1 over Ethernet (TDMoIP)

Next in E1 and T1 over Ethernet (TDMoIP) >>

MSRP: $650.00

Price: $480.00

Delivery in 15 days from order

Item Number: IPM-1SE-DC48

Manufacturer: CTCUnion

Manufacturer Part No: IPM-1SE-DC48

Quantity:

Add to a new shopping list

Email this page to a friend

The IPM-1SE-DC48 unit can send one E1/T1/J1 interface over Ethernet using TDMoIP technology. IPM-1SE-DC48 is available with neg. DC (36-72V) power supply input. There are also AC and DC24V power supply versions available. The IPM-1SE can extend TDM networks using the Internet as transport network. Thus, cost effective solutions are available for deploying highly expensive TDM networks into areas with Internet coverage.

Features of IPM-1SE-DC48 access unit
Supports synchronous TDM services and Ethernet over IP network
Offers Ethernet cascading ability to increase the number of TDM interfaces
Supports point-to-point E1, T1 or J1 over IP network transport
Supports clock recovery for the E1/T1/J1 interface
CLI, Telnet and SNMP management supported, upgradable firmware
DC 36-72V power available with 3 screw DC power connector

Technical specifications
Ethernet connectors: one RJ45 10/100Base-TX uplink port and one RJ45 10/100Base-TX LAN port
TDM connectors: E1 (both RJ45 120ohms and dual BNC 75ohms), T1 RJ45 100ohms,
Framing: Unframed, D4, ESF, PCM30, PCM31
Data rate: 1544Kbps / 2048Kbps
LEDs: PWR/ TD/ RD/ RTS/ DCD/ T-CLK Loss/ Red Alarm/ Sync Loss/ Yellow Alarm/ Err/ Test
Power: DC 3 screw block 36-72V connector
Temperature: 0-50ºC (Operating), 0 - 70ºC (Storage)
Humidity: 5%-90% non-condensing
Dimensions: 195mm x 235mm x 45mm
Weight: 1600g
Compliance: ITU-T G.703, G.704, G.706, G.732, G.823
MTBF: 57,000 hours

Additional information on IPM-1SE-DC48:

PDF Datasheet;

PDF Installation Manual.

For advice on your TDM-over-IP application please contact our sales department by e-mail or call us.

Related Products

IPM-1SE - Single E1/T1/J1 over IP/Ethernet extender - TDMoverIP - AC power MSRP: $600.00 Price: $460.00 The IPM-1SE-AC unit can send one E1/T1/J1 interface over Ethernet using TDMoIP technology. IPM-1SE-AC is available with AC (100-240V) power supply input. There are also DC48V and DC24V power supply versions available.	IPM-4SE - Four E1/T1 over IP/Ethernet extender - TDMoverIP - AC power MSRP: $1,450.00 Price: $900.00 Quantity: The IPM-4SE-AC unit can send four E1 or T1 interfaces over Ethernet using TDMoIP technology. IPM-4SE-AC is available with AC (100-240V) power supply input. There is also a DC48V and AC redundant power supply version available.	IPM-4SE - Four E1/T1 over IP/Ethernet extender - TDMoverIP - redundant AC and DC48V power supplies MSRP: $1,495.00 Price: $930.00 Quantity: The IPM-4SE-AD unit can send four E1 or T1 interfaces over Ethernet using TDMoIP technology. IPM-4SE-AD is available with redundant AC (100-240V) and DC48V power supplies.
TTU01-AC - Modular fractional T1 to Ethernet or Serial Data Port access unit AC powered MSRP: $600.00 Price: $400.00 Quantity: $TTU01-AC - Modular fractional T1 to Ethernet or Serial Data Port access unit AC powered$ The TTU01 access unit has a modular slot that accommodates Ethernet or Serial data ports to connect to fractional T1 (DS1) interfaces. TTU01-AC is available with AC (100-240V) power supply. Most common data ports are V.35 and X.21.